install guide 2013 ford edge front license plate bracket

This side should face inward to your vehicle. It will have the sticker with the Maine Turnpike Logo. Identify the flat side of your E-ZPass tag.You may order additional mounting strips by calling E-ZPass Customer Service atġ-888-MTA-PASS (1-88), Mon-Fri, 8 AM-6 PM

An extra set of mounting strips was provided with your E-ZPass order. Please note: Do not try to remove the mounting strips from your windshield and reuse them.Your E-ZPass tag may be removed by gently lifting one corner of the tag to separate the adhesive strips.

Place the tag in the correct position and press firmly against the glass for 15 seconds to achieve a good bond.

Turn the tag right side up facing you.

Without removing the second set of adhesive strips from the tag, carefully remove the protective backing from the mounting strips on the rear of the tag.

There are four adhesive strips: two are permanently mounted to the tag, and two are for mounting to the windshield.

If your vehicle has tinted glass, make sure the device is at least 1 inch below the tinted section of glass.

Locate the correct position for the tag - the upper center portion of your windshield behind the rearview mirror, at least 1 inch to the right of the mirror and at least 1 inch below the top edge of the windshield.

This side faces the interior of the vehicle with the arrows on the tag pointing toward the roof.

Identify the front face of your E-ZPass tag (it will have the label with the Maine Turnpike Logo and the tag serial number).

Clean and dry the inside of your windshield around the rearview mirror.

Vehicles with Special Windshield features.

Standard windshield and license plate mounts.

Install guide 2013 ford edge front license plate bracket